The Treatment Method for the Anti-slip Stair

The stair building is used as a component for inter-floor traffic. It is composed of continuous steps, platforms, and enclosure structures. Stairs must also be installed in high-rise buildings with elevators. Stairs are divided into two categories: ordinary stairs and special stairs. Common stairs include reinforced concrete stairs, steel stairs and wooden stairs. Special stairs mainly include safety ladders, fire ladders and escalators.

1. The plastic full paving method of step nosing

The method is mainly adopted by public ladders or extra-wide stairs. The material is made of plastic with an obvious anti-slip convex effect, bright color and convenient bonding. It is only suitable for engineering ladders and is an ideal choice for non-domestic ladders.

2. The anti-slip sand strip treatment method of step nosing

Anti-slip sand strips: stick 2 to 3 strips on the edge of the tread surfaces, which can play an anti-slip effect. The disadvantage is that the position that has been stepped on for a long time is easy to sand out, not beautiful, and not anti-slip, and there will be offset printing when it is replaced, which is difficult to remove. Its single color (paper yellow) is not compatible with stairs, which is not suitable for household use.

3. The inlaid metal strip treatment method of step nosing

Step nosing is mainly used at the edge of the tread surface on the stone surface. This method has an effective anti-slip effect, but there is also a long-term phenomenon of looseness after stepping. Once loosened, it is difficult to use glue to handle it, abnormal noise and retained dirt will also occur, the treaded part is bright, and other parts are black, which is very unsightly and is not suitable for households.

4. Carpet anti-slip treatment method of step nosing

Regardless of any stairs, there are many requirements for anti-slip, silence, protection of the tread surface, and beautiful coordination. Ladder carpet is actually divided into a coordinated proportion suitable for the width of the ladder for pasting.

5. Groove polishing anti-slip method of step nosing

Polishing the groove on the edge of the tread surface can also play an anti-slip effect, but as the tread surface wears, the groove will become shallower and the anti-slip function will be greatly reduced, and the groove will retain dirt, which is difficult to clean and is very unsightly. Few people have adopted this method.

6. Sticking particle anti-slip method of step nosing

It is mainly used for glass tread surfaces. Metal particles are attached to the surface of the tread surfaces. This has a good anti-slip effect and good aesthetics, but it is easy to fall off when people are stepping on it for a long time. This method is difficult for non-professionals, so it is not very common for customers.

7. Install aluminium stair nosing supplier

The plane and elevation of the stairs should be at 90 degrees. First, clean up the stairs. Apply all-purpose glue to the front edge of the stairs and the back of the anti-slip strip with the wrap angle. After it dries, glue it together. Hit the glued area with a rubber hammer, or punch holes in the aluminum alloy base, fix the aluminium stair nosing supplier with screws on the surface of the stairs, and finally insert a rubber strip on the surface. It has advantages of long service life, beautiful appearance, which is suitable for concrete, ceramic tile, wood, carpet (direct rod) and almost any other surface.